Become a Patron!
VT133 Not Reading Ohm and Battery Check Error
- Thread starter sub-zero
- Start date
Yup. Hmm lots of VT133 fans in here, I'm sure someone will chime in.
SirRichardRear
AKA Anthony Vapes on Youtube
VU Donator
Diamond Contributor
Member For 3 Years
Reviewer
@Wingsfan0310
He's our resident Vt133 expert. I tagged him so he can help. Good luck!
He's our resident Vt133 expert. I tagged him so he can help. Good luck!
If none of your atomizers are working it sounds lke you are probably having a 510 issue. It could also be a chip issue with the added battery check warning you are getting.
I would try a few things first. I would make sure I have the latest firmware running.
[RECOMMENDED]
*** 2016-08-08 EScribe 1.2 SP3 ***
https://downloads.evolvapor.com/SetupES250.exe (57MB standardalone installer)
I would clean all the contacts (510 on the mod and atty and battery contacts) with a q-tip dipped in rubbing Alcohol;. I would gently push on the 510 pin and make sure it is moving up and down as it should be.
Those are the easy things, if none of that helps I would either take out the screws of the 510 connector and make sure the wires leading to it are still soldered on well. That's only if you are comfortable doing this.
If that's not an option, depending on where you bought it from if it's still in the window when you can return it for a replacement or refund. I would go that route.
Finally if none of that works, I would open up a ticket with Evolv. Hope some of that helps.
https://helpdesk.evolvapor.com/index.php?a=add
Cheers,
Steve
I would try a few things first. I would make sure I have the latest firmware running.
[RECOMMENDED]
*** 2016-08-08 EScribe 1.2 SP3 ***
https://downloads.evolvapor.com/SetupES250.exe (57MB standardalone installer)
I would clean all the contacts (510 on the mod and atty and battery contacts) with a q-tip dipped in rubbing Alcohol;. I would gently push on the 510 pin and make sure it is moving up and down as it should be.
Those are the easy things, if none of that helps I would either take out the screws of the 510 connector and make sure the wires leading to it are still soldered on well. That's only if you are comfortable doing this.
If that's not an option, depending on where you bought it from if it's still in the window when you can return it for a replacement or refund. I would go that route.
Finally if none of that works, I would open up a ticket with Evolv. Hope some of that helps.
https://helpdesk.evolvapor.com/index.php?a=add
Cheers,
Steve