Is it the rta, or are you using factory coils?
I kept getting the ohms too low screen on my Alien with a .10ohms build. It should have fired it, but wouldn't. I manually changed the ohms reading so that the mod thought it was a higher resistance. My understanding is that this is not the best solution, but it worked perfectly fine for me. What is the resistance on the coil supposed to be?
To those more experienced, if he's using the .16ohms coil, can he raise the indicated ohms to the correct resistance if the mod is reading it low? I wouldn't even bring it up, but he's tried more than one coil.
I don't want to give bad advice, but if it were me I'd look at the reading on all of your available coils (same model I mean, and the reading from the mod, not what is engraved on the coil) and change the reading to the correct ohms. In my experience the Alien doesn't like it when you get close to the low ohm limit. Even if it's in spec.
If you DO try to change the resistance, don't make a big change. I always went from a .1 to a .25 reading, but that's me and MY mod. I would think that if you're getting a reading of .10 and you changed it to .11 you'd be fine.
Sent from my ONEPLUS A3000 using Tapatalk