I have never had an experience like last night and today. I gave up after snapping the 1st coil lead last night because I had to be up early.
Yesterday, I got Wotofo Sapor (for myself), a Freak Show V2, and a Battlestar 200 mod for my husband in the mail. I installed the twisted coils that came with the Freak Show into it and gave it to my husband to wick and use on his new Battlestar no problems.
I pretty much have been only using some 24 g kanthal wire to make simple coils for my RDAs, no issues with installation onto the CCI Archons (velocity and 3 post decks), my little Vaperz Cloud Nuevo, or my VC Mini Buddha 2.
I feel bad that I laughed at my husband for snapping that wire a few times in a row when I showed him how to build on the Archon. I take it back, I really do.
Now with the Sapor comes the ohms changing as soon as I heat the coils, and the snapping coils! Over and over. Really fuckin bad!!!! I just snapped 4 damn coils! WTF?
Finally, I was able to get a pair on there that stopped changing ohms after some tuning and tightening. I was going for around .42 ohms with a dual coil build of 24 g kanthal wrapped 9 times around a 3mm screwdriver. It is reading .38 on my 50 watt Aspire Zelos mod, and .373 on my Smok Majesty. At least it vapes now but DAMN!
Is it the Sapor RDA, the screws or posts, or just me?
My husband says maybe the screws are sharp and need a little sanding or something.
I am using the same damn wire and techniques I always do. I do have to move the first installed coil a bit to clip the middle lead on the second coil. I don't know, but I am still so mad about the whole thing.
Has anyone else had this damn wire snapping issue?
Yesterday, I got Wotofo Sapor (for myself), a Freak Show V2, and a Battlestar 200 mod for my husband in the mail. I installed the twisted coils that came with the Freak Show into it and gave it to my husband to wick and use on his new Battlestar no problems.
I pretty much have been only using some 24 g kanthal wire to make simple coils for my RDAs, no issues with installation onto the CCI Archons (velocity and 3 post decks), my little Vaperz Cloud Nuevo, or my VC Mini Buddha 2.
I feel bad that I laughed at my husband for snapping that wire a few times in a row when I showed him how to build on the Archon. I take it back, I really do.
Now with the Sapor comes the ohms changing as soon as I heat the coils, and the snapping coils! Over and over. Really fuckin bad!!!! I just snapped 4 damn coils! WTF?
Finally, I was able to get a pair on there that stopped changing ohms after some tuning and tightening. I was going for around .42 ohms with a dual coil build of 24 g kanthal wrapped 9 times around a 3mm screwdriver. It is reading .38 on my 50 watt Aspire Zelos mod, and .373 on my Smok Majesty. At least it vapes now but DAMN!
Is it the Sapor RDA, the screws or posts, or just me?
My husband says maybe the screws are sharp and need a little sanding or something.
I am using the same damn wire and techniques I always do. I do have to move the first installed coil a bit to clip the middle lead on the second coil. I don't know, but I am still so mad about the whole thing.
Has anyone else had this damn wire snapping issue?