Good day people!
I am ActionCow, and been vaping for a couple of years. Lately I have changed to SS316L coils with TC enabled. Although it looks like it is working fine, temperature protect does kick in, I have noticed that my temperature is jumping up and down, and the coils resistances are not being read intermittently, and leaves a blank space in device monitor (NFE Toolbox).
Any one of you have encountered this problem?
My setup is the following:
Evic VTwo Mini with latest ArcticFox firmware (171114)
VandyVape Kylin RTA
SS316L 26ga DUAL coil 10 wraps and 0.7 ohm each (0.4ohm total as read by the MOD, which goes up to 0.53 when reaching 235 Celsius; 455F)
I left the co efficiency at the default value for ArcticFox SS316L as Coil Wizard said the same values.
What I have tried so far:
Tried locking the resistance, and unlocking, same issue
Tried single coil, same issue
Tried spaced coils, and non-spaced coils, same issue
Tried unscrewing the 510 connector a bit, and tightening it, same issue
Tightened the coil clamps, disassembled the thing, reassembled the thing, same issue
Here is the device monitor snapshot of the issue:
https://imgur.com/a/8zPUz
I am seeking help resolving this issue and turning it into into a nice graph and vaping experience experience.
Thank you very much in advance!
AnctionCow
I am ActionCow, and been vaping for a couple of years. Lately I have changed to SS316L coils with TC enabled. Although it looks like it is working fine, temperature protect does kick in, I have noticed that my temperature is jumping up and down, and the coils resistances are not being read intermittently, and leaves a blank space in device monitor (NFE Toolbox).
Any one of you have encountered this problem?
My setup is the following:
Evic VTwo Mini with latest ArcticFox firmware (171114)
VandyVape Kylin RTA
SS316L 26ga DUAL coil 10 wraps and 0.7 ohm each (0.4ohm total as read by the MOD, which goes up to 0.53 when reaching 235 Celsius; 455F)
I left the co efficiency at the default value for ArcticFox SS316L as Coil Wizard said the same values.
What I have tried so far:
Tried locking the resistance, and unlocking, same issue
Tried single coil, same issue
Tried spaced coils, and non-spaced coils, same issue
Tried unscrewing the 510 connector a bit, and tightening it, same issue
Tightened the coil clamps, disassembled the thing, reassembled the thing, same issue
Here is the device monitor snapshot of the issue:
https://imgur.com/a/8zPUz
I am seeking help resolving this issue and turning it into into a nice graph and vaping experience experience.
Thank you very much in advance!
AnctionCow