Air Flow Control (AFC) Ring:
9mm tall
41mm OD
There are 2 larger 4mm X 11.8mm air holes with an extension that is 2mm X 11.8mm.
Additionally there are 2 holes that are 5.75mm X 4mm and 2 holes measuring 4mm round.
Juice Flow Ring:
6mm tall
41.2mm OD
There are 4 etched images that show lock and unlock to indicate if the juice flow is open of closed.
Between each is 3 grooves.
On the inner diameter of the ring are 4 notches to provide full stop locks for the juice control.
*NOTE: Be careful with these O-rings as they are thin.
They'll seal everything up just fine but when dry fitting the juice flow ring back on I managed to cut the very bottom O-ring.
This can be prevented by getting your O-rings wet.
Juice works well for this.
Base:
8.08mm tall
40.9mm OD with heavy knurling,
5.3mm deep
There is a large O-ring around the threading that connects it to the housing and a small O-ring that seals where the 510 of the deck go through the bottom.
There are 4 air flow holes measuring 10.5mm X 2mm.
On either side of the air flow holes there are the blocks that create the full stops.
On the bottom is says "Designed by BJ" and has a serial number.
Build Deck:
With pre-installed Postless option.
(shown in instructions as being called Standard Build Deck #1 on page 5)
16.15mm tall
27.8mm OD while measuring between the tabs, 28.6mm OD @ the tabs.
There are 2 juice flow channels measuring 9.9mm X 2mm
The ring that seals to the O-ring in the center of the base is 12mm OD
From the top of the standard build option posts to the inside bottom of the deck is 6.6mm
Distance between outside post holes is 14mm
Distance between center post holes (if you chose to use triple coils) 10.4mm
Post holes in this section are 2.5mm ID
The build: