Help wicking a mesh rda

I got the vandyvape mesh and I'm not sure if I'm doing it right. At first I put the mesh in and then the cotton and wrapped it around the mesh and could get about 5-8 hits before I had to drip again but it seemed like I was wasting juice cause around it the cotton was still wet. I redone it by putting the mesh on one side, put my cotton in then putting the other side of the mesh in and I got great clouds but have to drip every 3-4 times. Is there a way to get more hits and same cloud production? Any pics so I can see? Thanks in advance

I'd definitely check out some videos on YouTube. I don't mesh,but If I did. I'd learn there. I know there are others that will chime in that use mesh. Sorry I couldn't be more help

Sent from my Nexus 6P using Tapatalk

@Wtmke1
Your good and thanks. I like mesh, I think it's pretty good to whick and clouds. I'll look up more stuff about mesh.

Good luck, I find it to be finicky.
The way I have wicked my vandy vape mesh rda is

1. Install mesh into little rainbow shape and tighten down screws, dry burn a time or two to make sure I don't ha e any issues.

2. Grab a huge piece of cotton and roll and fold until it's roughly as big around as the hole under the rainbow.

3. Carefully and forcefully stuff it in the hole, working it around the pointy bits of mesh that likes to catch on the cotton.

4. Fluff cotton and trim the ends that stick out, usually have to use a screwdriver to stuff a little more of the sides back into the hole.

5. Juice, vape, and wonder why I went through all that for a lesser vape than I get off my regular coils.

6. Cuss when the rda leaks all over my mod and my hand and then put it back on the shelf til the next time I decide to try mesh again.