I have a FreeMax Fireluke Mesh tank, but I don't see a fill line on the tank or on the mesh 0.15Ω coil. What is the minimum fill line?
Sent from my LG-US996 using Tapatalk
Thanks. The reason I asked is because covering the cotton completely on that tank means filling it at least half way.If you want an absolute minimum, I'd say have the juice at least touching the cotton. I personally would at least cover the cotton entirely unless I was really low on juice
Sent from my XT1585 using Tapatalk
So this tank needs to be filled once it reaches less than ¾ full? That sounds pretty much impossible to use without constant filling.A little reading always helps, per Freemax Site, fill the tank 3/4 full.
http://www.freemaxvape.com/firelukemesh/
No, it's that when you fill it they recommend filling that much. You don't have to refill it until the juice reaches the bottom of your cotton unless you're worried. But when you fill it, they recommend that amount. Something to do with internal pressure something something.So this tank needs to be filled once it reaches less than ¾ full? That sounds pretty much impossible to use without constant filling.
Sent from my LG-US996 using Tapatalk
Ok, thanks. That answered my question (minimum fill being bottom of cotton).No, it's that when you fill it they recommend filling that much. You don't have to refill it until the juice reaches the bottom of your cotton unless you're worried. But when you fill it, they recommend that amount. Something to do with internal pressure something something.
Sent from my XT1585 using Tapatalk