26 guage ni 200 coil

[martybaker]

Hi,

I am trying to do a temperature control build on my rda and keep getting an error saying ohm too low on my smok alien.

Can somebody please recommend a coil that would work?

Hobart, Tasmania

 

[f1r3b1rd]

I don't know much about smok products, but I know with nickel most mods used to require at least a 0.1 ohm build.
Again, I'm not sure if that's the case with smok or not.
With ni200, I always used 28g and would need upwards of 10 wraps to get there. With 26g I was using 13wraps. Which is why I stopped using it.
IMO, ni200 sucks to build with.

If that's not the case try checking your post holes and seeing if you can get a build of known value to register on the mod.

Sent from my XT1650 using Tapatalk

 

[HondaDavidson]

Get thinner wire if Ti or Ni or go to SS wire.
I would use Steamengine or other calculator. To find a wire and wrap combo that will give me 8 to 10 wraps at the target OHM.

Sent from my SCH-I605 using Tapatalk