discrete vaping setup? (minimal vapor production)

Discussion in 'General Requests' started by nichiren-123, Nov 22, 2017.

  1. nichiren-123

    nichiren-123 New Member

    Blog Posts:
    0
    Joined:
    Nov 19, 2017
    Messages:
    4
    So I mostly vape on my cleito exo with an eleaf ipower box mod and 6mg/ml of nicotine. However I can't smoke indoors without setting off my fire alarm. Also, I feel a bit silly walking down the street blowing these huge clouds about the place.

    So I wan't to get something more discrete (in terms of physical size and vapor production) so I can smoke indoors at home and on the street but at the same time I want something with a kick, i.e. throat hit and high nicotine.

    I've used my cool fire IV mod but I find it too chunky and want something closer to a traditional pen rather than a box mod.

    So what vape and ejuice should I get to meet these needs?

    thanks
     
  2. HeadInClouds

    HeadInClouds Platinum Contributor Member For 3 Years ECF Refugee Unlisted Vendor Vape Media

    Blog Posts:
    0
    Joined:
    Jun 29, 2014
    Messages:
    5,311
    As far as the juice is concerned, you can kill 2 birds with 1 stone. Higher PG gives you less vapor and more throat hit, no matter what hardware you choose. You can still buy pen-style setups, but I'll leave recommendations on that to someone more familiar with what's still available in that type.
     
  3. omghax

    omghax Member For 2 Years

    Blog Posts:
    0
    Joined:
    Jan 21, 2015
    Messages:
    13
    I remember seeing some "stealth e-juice" from the UK (or perhaps EU) that was basically 100% PG which produced little to no vapor, I've been wanting to test this but I keep forgetting when DIY'ing.

    I'm sure someone has done this, I'm curious what their results were - how much vapor was produced compared to normal 30/70 or 50/50? I prefer a nice throat hit anyway I'm usually at 70/30 but all I notice is the viscosity difference.

    Thanks
     

Share This Page

Close This Message