arrowcrest
Member For 4 Years
I've been building regular coils for about a year but that was for temp control and I'm going back to watts mode.
My question is I want to build dual claptons using Kanthal for center wire and outer wrap. I need suggestions for inner and outer wire sizes for the Big Baby Beast. I want to build 3mm id and have a warm vape. I am using a IPV 4S mod but don't know what finished ohm reading I should go for? I also have other RBA tanks, U Well Crown and Vapers Cloud VCMT and wondered where to start with them? Of course the U Well is a single coil and that one would need to be 2.5 mm ID.
Thank You
Any help would be great!
My question is I want to build dual claptons using Kanthal for center wire and outer wrap. I need suggestions for inner and outer wire sizes for the Big Baby Beast. I want to build 3mm id and have a warm vape. I am using a IPV 4S mod but don't know what finished ohm reading I should go for? I also have other RBA tanks, U Well Crown and Vapers Cloud VCMT and wondered where to start with them? Of course the U Well is a single coil and that one would need to be 2.5 mm ID.
Thank You
Any help would be great!