Become a Patron!

Help with voopoo drag

Have a new drag that reads all coils as .16 or .17 resistance. Does anyone know how to roll back firmware or have any other advice?
 

lucifah

Shinyitis Victim
VU Donator
Bronze Contributor
Member For 3 Years
There's only one firmware available: 1.0.0.1. So rollback isn't really possible. You could try to install the same thing again. Other than that, I'd go into the VooPoo configuration software and set everything back to default values (big default button on almost every configuration page). Maybe that fixes it?

Software here, if you don't have it: http://en.voopootech.com/download-support

Have you tried a different atty? Maybe something wonky going on there?
 
There's only one firmware available: 1.0.0.1. So rollback isn't really possible. You could try to install the same thing again. Other than that, I'd go into the VooPoo configuration software and set everything back to default values (big default button on almost every configuration page). Maybe that fixes it?

Software here, if you don't have it: http://en.voopootech.com/download-support

Have you tried a different atty? Maybe something wonky going on there?[/QUO

Rebooting laptop, going to try everything I can in the software. I have tried 8 different tanks with about 10 different builds. But will try this again and see if it works.
 
So I don't know what combination worked, but one of them did, and it will now read the right resistances. And there was much rejoicing.
 

VU Sponsors

Top