I was goofing off looking for mods for the MVP v2 and came across this tut I thought would be useful.
If you've fried/stripped/mashed your MVP's 510 connector or just want that fugly eGo-threaded thing gone for a flush fit, this might just help ya.
Note: It is pointed out later in the thread that the wires should be cut close to the 510 and then fluxed and re-soldered on to the new connector, not just cut and twisted together with tape. Also, utilizing some heat shink tubing is a good idea as well for a clean and safe mod.
Imgur album tut: http://imgur.com/a/rsSKu
Original thread: http://www.reddit.com/r/electronic_...placing_mvp2_stock_510_for_flush_sitting_510/
Credit goes to the OP, marleyinohio from Reddit. Thx!
If you've fried/stripped/mashed your MVP's 510 connector or just want that fugly eGo-threaded thing gone for a flush fit, this might just help ya.
Note: It is pointed out later in the thread that the wires should be cut close to the 510 and then fluxed and re-soldered on to the new connector, not just cut and twisted together with tape. Also, utilizing some heat shink tubing is a good idea as well for a clean and safe mod.
Imgur album tut: http://imgur.com/a/rsSKu
Original thread: http://www.reddit.com/r/electronic_...placing_mvp2_stock_510_for_flush_sitting_510/
Credit goes to the OP, marleyinohio from Reddit. Thx!