Become a Patron!

Mesh RDA.

Ohmniscient

Member For 1 Year
Soooo.. Picked one of these up recently. Using Ni80 mesh that I’m almost out of. My problem is that when firing it up, not only is it starting on one side, (not the middle of the coil like I’m used to) but also the resistance is jumping around from 0.11-0.15 when on my mod. On my Ohm reader it sits at 0.14. I just don’t want the resistance jumping because I wanted to put this on a squonk mod.

Build pics

4ef1cdb29e4addacde6f3b3a4b2a68d2.jpg
2994eb33159f9cce4d3f529927c8473a.jpg
1df566a0f370d0380476019052d218af.jpg
5dc6cb70b3a1a235ae4519820c319ca2.jpg
8a03864fe076bad2b2997bfecf681d6e.jpg



Sent from inside a very cloudy room off my iPhone
 

Attachments

  • IMG_1342.JPG
    IMG_1342.JPG
    156.9 KB · Views: 5
  • IMG_1343.JPG
    IMG_1343.JPG
    184 KB · Views: 5
  • IMG_1344.JPG
    IMG_1344.JPG
    141.1 KB · Views: 5
  • IMG_1345.JPG
    IMG_1345.JPG
    145.6 KB · Views: 5
  • IMG_1346.JPG
    IMG_1346.JPG
    145.1 KB · Views: 5

fuseryder

Silver Contributor
Member For 4 Years
Member For 3 Years
Normal for mesh, cut a very small strip off one side to see if it evens out

Sent from my Pixel 2 using Tapatalk
 

Ohmniscient

Member For 1 Year
It seems to have evened out at .11. I can’t seem to get a build with mesh much higher without it being too tall making it very close to my drip tip. I knew .14 was already probably too low for the batteries I have. So now I guess it’s off to get better batts


Sent from inside a very cloudy room off my iPhone
 

VU Sponsors

Top