My first Mod Need Suggestions Completing it

[gunlocators]

Hey fellow vapers. This is my first Mod Build mainly out of parts I had laying around. Looking for suggestions. I basically have this mocked up for now. I used a Spare AR15 grip with bottom floor plate access. 510 Connector, 18ga zip wire and to conceal the wires up top I used some Kydex that I use to build holsters for guns. I think it looks good. Any precautions I should take? Also I used a momentary switch that i found in my parts box from Ham radio projects. Not sure if I need to add any circuit protection. I still need to get some 18650 battery holders to place in grip to hold the battery.

 

[Wabah58]

You're gonna wire in a mosfet with that switch.

 

[gunlocators]

I think so I am afraid if I dont I will have a fried switch. Wheres best place to get mosfet...

 

[Wabah58]

http://www.mouser.com/ProductDetail/International-Rectifier/IRLB3034PBF/?qs=sGAEpiMZZMshyDBzk1/Wi5%2bqVgN3%2bWS8iNZUeqPPDAc=

That is the mosfet preferred by box modders, need the 15k 1/4- or 1/2 watt resistor too. You can get the mosfet and resistor as a kit of sorts on ebay too.

You can pick up the mosfet and resistor as a package too just put this in ebay search
IRLB3034PBF

 

[gunlocators]

I have 2 of these in my parts bin will these work
http://www.mouser.com/Search/Produc...irtualkey61360000virtualkey781-SUP75P03-07-E3

 

[Wabah58]

I have 2 of these in my parts bin will these work
http://www.mouser.com/Search/Produc...irtualkey61360000virtualkey781-SUP75P03-07-E3

Those are P channel, You really want a n channel.