Become a Patron!

Need build ideas for my first mech mod

Stedke

Bronze Contributor
Member For 3 Years
Member For 2 Years
Member For 1 Year
Hello fellow vapers!! Ok just want to start off and say I am aware of ohms law and battery safety. With that being said I was given a limited edition cartel clone from a friend at a local B&M. The 2 rdas I want to stick with this on mech is the 22mm norris rda authentic and the 22mm stillair clone. My battery I will be using with this is an lg he2. Thanks in advance!!! Btw I like a warm vape.
 

Neunerball

Platinum Contributor
Member For 4 Years
Member For 3 Years
ECF Refugee
Hello fellow vapers!! Ok just want to start off and say I am aware of ohms law and battery safety. With that being said I was given a limited edition cartel clone from a friend at a local B&M. The 2 rdas I want to stick with this on mech is the 22mm norris rda authentic and the 22mm stillair clone. My battery I will be using with this is an lg he2. Thanks in advance!!! Btw I like a warm vape.
Use http://www.steam-engine.org/coil.asp as a guideline. However, use an Ohm meter to verify proper build, and resistance.
 

Stedke

Bronze Contributor
Member For 3 Years
Member For 2 Years
Member For 1 Year
Thx all, I haven't found anything yet that really pops for me
 

nightshard

It's VG/PG not PG/VG
VU Donator
Gold Contributor
Member For 4 Years
As a rule, for a single battery mech you should not go below 0.22 for a 20A battery and 0.15 for a 30A battery.
SS will get you in the danger zone much easily since it has much lower resistance then Kanthal.
I suggest you start with Kanthal or N80 and not SS.
Use a coil calculator to get you you started and figure out what's safe to build and what's not.
http://www.steam-engine.org/coil.asp
 

Stedke

Bronze Contributor
Member For 3 Years
Member For 2 Years
Member For 1 Year
Steam engine is a very good calculator for coils, I also like the Vape tool app in Google play
 

VU Sponsors

Top