Need help!!!

[ZombieMan_0878]

Hello out there,
I just got a spool of GeekVape SS Juggernaut coil wire, and I've been trying to use a 6 wrap spaced coil configuration for the Zeus RTA, reading at approximately .4 ohms. Yet when I dry burn the coil, the resistance gradually increases to approximately .6ohms. I have tried building multiple coils, with multiple tanks on multiple devices, with the same result. Can someone provide some insight as to why this is occurring and how to reslove this issue?

 

[zephyr]

Do you retighten the post screws after you heat the coil?

 

[ZombieMan_0878]

Do you retighten the post screws after you heat the coil?

Yes, I did. Same results.

 

[zephyr]

Well, SS goes up in resistance after heating it up, .4 to .6 seems like a lot...but does it vape well?

 

[ZombieMan_0878]

I haven't tried to vape on it, I don't dare. I primarily use SS, but have never had this issue.

Well, SS goes up in resistance after heating it up, .4 to .6 seems like a lot...but does it vape well?

 

[zephyr]

I see - Well, I might suggest unwrapping the ribbon from the legs so that only the two 28 cores go into the post holes. If the resistance still goes up that much after that, I am out of ideas. Good luck

 

[ZombieMan_0878]

I see - Well, I might suggest unwrapping the ribbon from the legs so that only the two 28 cores go into the post holes. If the resistance still goes up that much after that, I am out of ideas. Good luck

I'll give it a shot. Thank you.

 

[ZombieMan_0878]

I see - Well, I might suggest unwrapping the ribbon from the legs so that only the two 28 cores go into the post holes. If the resistance still goes up that much after that, I am out of ideas. Good luck

Still no dice.

 

[zephyr]

@The Cromwell Is it normal for SS to increase this much, it's two strands of 28 awg wrapped in ribbon

 

[ZombieMan_0878]

@The Cromwell Is it normal for SS to increase this much, it's two strands of 28 awg wrapped in ribbon

Not at all, I've contacted GeekVape, but they're clueless.