Question about temp control

[Vapervader28]

I just picked up a ipv4s and and wanting to try the temp control, i am currently using my aspire triton with a .4 ohm coil, my question is do i use the ni200 or ti01 setting and whats a good temp to vape at without melting my coil or burning my face off?

 

[dcegan12]

You need to be using a nickel coil head. As far as I know the .4 ohm coil that comes with it is stainless steel and wont work with temp control. as long as you have a nickel coil head, I usually vape anywhere from 425 to 500 depending on the juice, but I am also just getting into temp control and my experience is limited. I would say start low and work the temp and the joules up to where you feel satisfied with it

 

[Vapervader28]

Ya, im looking at trying a drip head soon

 

[cavtruper]

^^^
Yep. Make sure you have Ni coils, then obviously select Ni setting
http://sweet-vapes.com/clearomizers...antis-ni-200-nickel-organic-cotton-coils.html like these.
I didn't shop price or reputation of vendor but this is an example

 

[f1r3b1rd]

Like the others said You need nickel coils. 'NI200', some mods let you use titanium(TI), but I'm not sure if TI coils are available for aspire.
Ive used a bunch of the ni200 offering that are compatible with the triton, the best I've found are the eleaf ni200 coils, they seem to have much better airflow and last a little longer . I got mine from
http://sweet-vapes.com/clearomizers...f-coils/eleaf-ijust-2-ec-tc-coils-ni-200.html


Like the others said, set it for 'Ni' lock it in, and ready to roll...im normally around 35-38j and 510° but start low and find your sweet spot, sometimes dropping the power and raising the temp can make a better vape. you just have to fiddleduck for a bit with the settings absinthe airflow.

Enjoy and congrats!!!!