RDA Deck question

[DODoubleG]

Hey folks,

I was building my second and as usually you need to cut the excess lead . I did it, but there is some left and I cannot cut it more. Should I worry? I tighten the screws also put the rda on the ohmmeter and it and it shows as its supposed to (0.24 ohms)

I added some photos.


Thanks

 

[MyMagicMist]

Nah, your excess isn't anything to be too concerned over unless you got it brushing up again a metal topper cap. Need to be careful with those caps and excess wire. You'll short your coil out should the wire touch the metal topper/s. That might break the coil as in it burns it through, it snaps, the wire simply refuses to hold current through itself. Usually if this happens you rebuild a new coil and install it on the deck and go again. The excess your pictures show seems about how I sometimes leave mine, you can only get so much. I don't have any issues, normally. Sorry it took someone a bit to get back to you, at least in the clear here.