Subtank mini

[cordar]

built at 1.4 ohms organic cotton as wick. Using rebuildable deck. If i go past 20 watts its burnt. Is this tank not capable of wicking juice fast enough?? My wick isnt to tight or to loose. Any thoughts? Thanks

 

[BKTOAD]

The rba doesn't play well with high vg in my experience. Not sure if thats what you are using.

Depending on your build, 1.4 ohms can be a pretty high resistance to crank 20+w through IMHO. If not burnt, would vape pretty hot. Vape pens usually have a 1.8ish ohm coil and that is at like 8w or so. More details on your build could help. A normal coil at 1.4ohms is gonna take a lot less wattage than a clapton 1.4ohm.

Could try to close off the air supply a bit. Have found it can improve the juice feed on these type of rba's. Seems counter-intuitive to me, but I assume it increases the vacuum and pulls juice in through the channel/hole.

Also, poke your wick back in the juice hole a little bit.

 

[f1r3b1rd]

On a single coil with 28g at 1.4w I would be around 3.4v or 8.25w...


OVERPOWER it and it will be too hot for the wicking to keep up

 

[RatRacer]

The 2 1.4 ohm coiled tanks I have sitting here are set to 14.5W and 15.3W.

 

[Zamazam]

You have a v1 deck, The next version has holes drilled in the "chimney" that allow juice to flow into the chamber faster.

 

[cordar]

Thanks for your replies!!