Supertank mini 25 with CoilArt coils question.

[BPROSEK]

Hey all. So had a question on using the CoilArt.2 notch coil with my Supertank mini 25.

When installed the base of the coil causes the 510 pin to protrude quite far. Wondering if this is gonna end up causing a problem with my mods? Currently using it on an alien and I can now see an indent from the base of the 510 on the top of the mods 510 pin.

Although the coil is giving great flavor (note it reads as .3 not .2 like stated on packaging) I'd much rather trash them as opposed to trashing my mod...

Thanks in advance.

 

[BPROSEK]

Chances are if you have spring loaded 510s on your mods, (most reg mods do) you'll be alright.
Screw the tank down slowly, paying attention to the turning resistance as you near the bottom,
and see if it seats in the 510 (bad) or lands flush on the mod.

Right on man thanks, it does sit flush with no resistance, although earlier when I was putting it on my wrecker g2 I did hear/feel a slight pop when screwing it down.... Hoping for no issues.... Was a little concerned with the dent in too of the alien pin... Will prolly just trash the coils to be safe.