I have already purchased the following components, and realized that some of the charts I see online require a resistor (at varying strengths) soldered to the mosfet. I have three questions:
1. What "strength" resistor do I need?
2. Is a higher "strength" resistor (27k) better than a lower strength (15k)?
3. What kind of master "on/off" switch (mounted internally) should I buy?
Here are the parts I have, currently:
I just ordered the following from Amazon:
Can someone please help me find suitable resistors and a master on/off switch on DigiKey?
1. What "strength" resistor do I need?
2. Is a higher "strength" resistor (27k) better than a lower strength (15k)?
3. What kind of master "on/off" switch (mounted internally) should I buy?
Here are the parts I have, currently:
- x1 Hammond 1590
- x1 AOI510 Mosfet
- x1 E-Switch
- x1 Alpinetech Switch (Alternative to E-Switch)
- x1 Fat Daddy v4 510 Connector with All Ring Sizes
- x1 Keystone 1048 Battery Sled
- 1/4" Magnets for Enclosure (Home Depot)
- 12ga & 14ga Stranded Copper Wire (Home Depot)
- Solder & Flux Paste (Home Depot)
- Heat Shrink Tubing (Home Depot)
I just ordered the following from Amazon:
Can someone please help me find suitable resistors and a master on/off switch on DigiKey?
Last edited: