wisemec reuleaux rx200 atomizer low msg

[TheGoyaGod]

So I just grabbed the reuleaux rx 200 not too long ago, but I noticed on one of my builds which reads at 0.3ohms that once it's on the mod it keeps reading out atomizer low. I've read online that it can be from there possibly being a short, but I made sure no wires are touching one another and the deck actually has 2 different positives so each coil never touches. How do I fix this?

Sent from my D6708 using Tapatalk

 

[fq06]

Are the coils touching the cap or any part inside the atomizer other than the holes the leads are supposed to go into?
Are the screws holding the leads tight?

 

[pusher989]

I just had this problem. I figured I had a short but any other atty I put on it had the same problem. Long story short I downgraded the firmware then upgraded to 3.00 works like new! Hope this helps

Sent from my SM-N910W8 using Tapatalk

 

[fq06]

If that's the fix at least flashing this thing is about as easy as it could possibly be.

 

[Moueix]

JUST got my first Reuleaux in today. LOVING the thing so far.. don't want to drop it on my TOES though, lawd! Heavy!