Hey guys I almost never post so I apologize if this has been answered but I didn't see it. I've been looking into customizing my rx200 and all I see is tutorials on editing fonts and themes. I vape at 100W outside of tc mode on my wismec rx200. As a result I use .2 ohms coils. This means that if I hold down the fire button for more than 2 seconds I get a burnt hit. Is it possible to change my second protection limit from 10 seconds to 2 seconds? I tried to do it using the editor you can download by changing the numbers in the second protection category from 10 to 2 but it didn't change it.
Become a Patron!
About customizing rx200 firmware
- Thread starter af0926
- Start date
howdy! and welcome! not sure about the programming aspect, but what about lowering your wattage and allowing it to ramp up a little?
What type of coil? I vape my aliens at 100 watts and don't get burned hits, as long as I have enough juice and the right wicking. I'm using cotton bacon v2 atm.
I have a uwell rafale tank
Thanks for your help everyone
OK so can you edit rx200 and rx200s firmware from a MAC? I downloaded NFirmware but it only works on Windows! Any editing software for MACs?