I have the material and taps to make some pins for the original Atomic, Not the clone. I don't know the size of the clone pin so not sure if it will fit. I have a couple hundred screws as well. cheese head and regular phillips.
I am going to have a couple made for myself. I don't have access to a lathe any longer so I am going to have these made.
Is anyone else interested in haveing a direct replacement center pin for a bottom feed atomic?
I am going to leave the feed cross hole out unless everyone wants them in the same place. I am putting mine a little higher up off the deck to supply the wick with more juice as if you where dripping from the top.
Not sure of the cost at this time and I am sure it depends on how many we have made. I am using tubing so it will only take about 2 cuts on the o.d and then drill and tap for the lead screw hole and then drill the coil lead hole. only one lathe setup and one mill setup so it shouldnt be that bad.
let me know of any interest please.
I am going to have a couple made for myself. I don't have access to a lathe any longer so I am going to have these made.
Is anyone else interested in haveing a direct replacement center pin for a bottom feed atomic?
I am going to leave the feed cross hole out unless everyone wants them in the same place. I am putting mine a little higher up off the deck to supply the wick with more juice as if you where dripping from the top.
Not sure of the cost at this time and I am sure it depends on how many we have made. I am using tubing so it will only take about 2 cuts on the o.d and then drill and tap for the lead screw hole and then drill the coil lead hole. only one lathe setup and one mill setup so it shouldnt be that bad.
let me know of any interest please.