Aromamizer Supreme Allen Key Replacement

[seylvape85]

Does anyone know if the attached driver is the correct size for the hex screws in the Aromamizer Supreme?

I've read that the MIP (thorp) driver wrench is one of the best ones you can buy. I also believe I read that a 1.3mm driver works great in the original Aromamizer so I'm assuming its the same size for the Supreme.

Lastly, Anyone have any thoughts or opinions on the screws and hex driver that comes with the supreme? Same as the v1 or does it seem to be of better quality.

Thank you so much everyone!

 

[raymo2u]

1.27mm Drivers/Keys will work, Bondhus makes some nice drivers that work very well

 

[roxynoodle]

I thought it was the same. Supposedly it's 1.27mm, but a 1.3mm driver has worked for me.

 

[seylvape85]

1.27 and 1.3 are so close I just wanted to make sure you don't have to jam the 1.3mm in there to get it to work and that its not also a pain in the ass to get the driver out after your done tightening the allen heads.

Roxy, have you actually tried it on the supreme or just the v1 and the boreas?

 

[seylvape85]

Raymo, when I looked up that part number it said it was a ball end hex. Aren't those a little iffy vs the flat sided hex drivers? Maybe I'm mistaken and the part number is used for both the ball end and flat end hex drivers by them.

I was reading on some rc forms that MIP (Thorp) hex drivers are some of the best professional drivers out there. I just want to make sure the 1.3mm works without a hitch

Thank you everyone for the advice/ opinions!

 

[raymo2u]

Raymo, when I looked up that part number it said it was a ball end hex. Aren't those a little iffy vs the flat sided hex drivers? Maybe I'm mistaken and the part number is used for both the ball end and flat end hex drivers by them.

I was reading on some rc forms that MIP (Thorp) hex drivers are some of the best professional drivers out there. I just want to make sure the 1.3mm works without a hitch

Thank you everyone for the advice/ opinions!

They are Carbon Steel Keys, it doesnt bother me with these types of drivers as they wont strip the first go and if they do put the tip in a vice and break it off and grind down the surface flat...a new flat end

 

[seylvape85]

haha! Your a little more ambitious then me . I really just want to find something that works good and last. These MIP drivers supposedly have a lifetime warranty on them and get replaced if they ever round off.... which apparently doesn't happen. Just worried I'll spend all the money on this and 1.3mm will actually be a pain to use vs 1.27mm. I guess I can always take the plunge and find out

 

[roxynoodle]

1.27 and 1.3 are so close I just wanted to make sure you don't have to jam the 1.3mm in there to get it to work and that its not also a pain in the ass to get the driver out after your done tightening the allen heads.

Roxy, have you actually tried it on the supreme or just the v1 and the boreas?

I used it on the v1 Aromamizer only. And then contacted Steam Crave to ask what size it was. 1.3 was very tight.