Atomizer short question

[emsvapor]

I need some advice guys.

I built a 7 wrap 24g dual coil on my Freakshow the other night and it worked like a champ.

I went to use it this morning and it worked as expected for about 6 vapes and now it's giving a atomizer short. No leads or any part are touching the posts or barrel.

Any thoughts or ideas on what could be causing the short?

Thanks in advance for your help

Sent from my C6725 using Tapatalk

 

[iSubOhm]

Try tightening down your leads. And unscrew your atty and clean your connections really well. I usually use a q-tip with 91% iso

Sent from my SM-N910T using Tapatalk

 

[emsvapor]

Try tightening down your leads. And unscrew your atty and clean your connections really well. I usually use a q-tip with 91% iso

Sent from my SM-N910T using Tapatalk

I'll give that a shot when I get off work

Sent from my C6725 using Tapatalk

 

[suprtrkr]

Yeah, +1. Try tightening everything up.

 

[chinacatsunflower-]

If none of that works, just make a new coil.

Also, if you have an RX200 it sometimes will read "Low Atomizer" when there isn't anything wrong. To be on the safe side though, put it back on your ohm reader to test for the short and if it checks out then do the following:

Press the fire button on your RX200 without the atty for the "No Atomizer" message and then screw it back on, check to see if it reads it, if it does, you're good. Simple fix!