AW 18490

[wdt258]

Anyone have an idea or has seen a test on this battery? Wanted to find out what the continuous discharge amperage was for it. Is it worth adding a modular piece to my mech so it will heat up faster?

 

[smacksy]

Anyone have an idea or has seen a test on this battery? Wanted to find out what the continuous discharge amperage was for it. Is it worth adding a modular piece to my mech so it will heat up faster?

I only have that battery in my low powered Provari.. Its a button top rated at only 10A, if I remember right..quit using the Provari two years ago...lol

Sent from my XT1080 using Tapatalk

 

[wdt258]

I only have that battery in my low powered Provari.. Its a button top rated at only 10A, if I remember right..quit using the Provari two years ago...lol

Sent from my XT1080 using Tapatalk

So i was wondering what a safe build would be for it. I figured it can heat up faster than my 18350 and i can build lower

 

[Neunerball]

So i was wondering what a safe build would be for it. I figured it can heat up faster than my 18350 and i can build lower

The AW 18490 1200mAh has a 18A continuous discharge rate.
Check out http://www.steam-engine.org/batt.asp?b=AW_IMR_18490&mah=1200&c=15

 

[wdt258]

The AW 18490 1200mAh has a 18A continuous discharge rate.
Check out http://www.steam-engine.org/batt.asp?b=AW_IMR_18490&mah=1200&c=15

Mine is a 1100 mah, just was tryin to see if any tests were done and someone can conclude a safe amount of amps. A safe build for it..

 

[wdt258]

Are these two low?

 

[Neunerball]

The resistance of both coils would be OK. However, you would put a lot of stress on the batteries and they won't last long either.

 

[wdt258]

The resistance of both coils would be OK. However, you would put a lot of stress on the batteries and they won't last long either.

Cool man thanks, yeah probably a .4 would be good and not as much stress. Thing is with a .55 build with my 18350 just doesnt heat up quick on my tomahawk mod, the 490 is just a little longer.