Battery on Ijust2 finally wore out. Need suggestions for a new (simple) mod!

[rj9923]

I've been vaping a 0.5 ohm dual coil build inside a Velocity clone on top of an Ijust2 battery for quite some time now. Lets just say that I used it so much that the button barely works and the battery won't hold any charge.

I need suggestions for a new (simple and cheap) mod! Right now the only backup mod I have is a beat up IPV4 with a defective chip someone gave me that barely works. The IPV4 needs a lot of tinkering just to vape a little, so I need something new very soon before I start craving analogs more.

My Ijust2 was only 40 watts, and that was perfect for me. So I want something that outputs at least 40-60 watts. It doesn't even need variable voltage or wattage. I do prefer something with a chip though for safety reasons. I don't think I'm ready for a mech yet. And it doesn't have to fire below 0.3 ohms because the lowest I go is 0.5... Price range? 20$ tops, since that's how much the Ijust 2 costed me (with a tank included).

Any cheap mods you know of that meet these specifications? And no, I don't need an upgrade to a fancy 200 watt mod with temp control like many of you have. The 40 watts I had with the Ijust2 were just perfect for my needs. Thank you

 

[shawn.hoefer]

I've been vaping a 0.5 ohm dual coil build inside a Velocity clone on top of an Ijust2 battery for quite some time now. Lets just say that I used it so much that the button barely works and the battery won't hold any charge.

I need suggestions for a new (simple and cheap) mod! Right now the only backup mod I have is a beat up IPV4 with a defective chip someone gave me that barely works. The IPV4 needs a lot of tinkering just to vape a little, so I need something new very soon before I start craving analogs more.

My Ijust2 was only 40 watts, and that was perfect for me. So I want something that outputs at least 40-60 watts. It doesn't even need variable voltage or wattage. I do prefer something with a chip though for safety reasons. I don't think I'm ready for a mech yet. And it doesn't have to fire below 0.3 ohms because the lowest I go is 0.5... Price range? 20$ tops, since that's how much the Ijust 2 costed me (with a tank included).

Any cheap mods you know of that meet these specifications? And no, I don't need an upgrade to a fancy 200 watt mod with temp control like many of you have. The 40 watts I had with the Ijust2 were just perfect for my needs. Thank you

Two thoughts... Hana Modz has some of their ONE mods on sale around $20. That's a DNA 40 board, but the mod is kinda cheap feeling... ok... not kinda...

Ecig.com has, I think, the Dovpo Punisher 80 for $20 if you hurry.

You might be able to find an iStick 40 or 50 for that, too.

Sent from my SAMSUNG-SM-N910A using Tapatalk

 

[gingerbread]

Pico, cost around $20-30 (depending on whether you get the tank). However what Shawn suggested is a good idea. An earlier version of a mod with a good chip. The best chip is the DNA. You might want to get another back up due to pending changes if you live in the US.
Good luck.

 

[RayCray Cray]

I second the Dovpo punisher. Single 18650 80w device. Nice build quality and finish. Ecig.com always has a few coupon codes floating around too. 18-19$

Sent from my SM-G935T using Tapatalk