I’m new to the DNA200 mod world so there must be something I’m not setting up correctly because I can’t get my new Lavabox DNA200 to give the hit the iPV D2 gives me using the same Velocity 0.12 Ni200 build in temperature mode on both devices. I made sure to lock resistance correctly at room temperature on both devices
With the iPV D2 set to 400° and 40 joules I get good vapor and excellent flavor with the juice I’m using. I get no burnt hits and things run smoothly.
Like I said, with the same Velocity and same coils on the Lavabox I have the temperature all the way up to 500° and up to 60 watts but still not getting near the same vapor hit. I know I can go much higher with the temperature and wattage but I’m trying to figure out why there is so much difference.
I have the Lavabox setup in the Escribe software with 100 watts preheat power currently for 1 sec, tried preheat punch from 3 to 10. The battery settings are using LiPo capacity at 11.1 Wh (was at 9.99 initially) and cell soft cutoff at 3.09 V. The mod resistance is 0.007.
If anyone can shed some light I would appreciate it greatly.
With the iPV D2 set to 400° and 40 joules I get good vapor and excellent flavor with the juice I’m using. I get no burnt hits and things run smoothly.
Like I said, with the same Velocity and same coils on the Lavabox I have the temperature all the way up to 500° and up to 60 watts but still not getting near the same vapor hit. I know I can go much higher with the temperature and wattage but I’m trying to figure out why there is so much difference.
I have the Lavabox setup in the Escribe software with 100 watts preheat power currently for 1 sec, tried preheat punch from 3 to 10. The battery settings are using LiPo capacity at 11.1 Wh (was at 9.99 initially) and cell soft cutoff at 3.09 V. The mod resistance is 0.007.
If anyone can shed some light I would appreciate it greatly.