Become a Patron!
CIGPET ECO12 (with RBA section)
- Thread starter Paratech
- Start date
Glass:
28.15 OD X 28mm tall
Drip Tip:
16.1mm OD
13mm ID tapering down to 9mm
13mm tall
Top Cap:
26mm X 6.6mm
12.6mm ID with a lip that creates 11.75mm ID
Top:
19.6mm tall X 28mm OD
8.6mm ID chimney
4.5mm X 19.6mm juice fill holes
Last edited:
Base:
26mm OD at bottom
28.1mm OD at knurling
15.1mm tall
18.5mm ID at threading
14.4mm deep
15.5mm X 2.5mm air flow holes
Deck 2:
13.5mm wide coil fits fine
2.9 X 3.5mm ID juice flow holes
Framed Alien Staple 3.5mm ID 6 wrap from b_d_builders came in at 0.12Ω
Last edited:
No overhang, plenty of room.
On the Ijoy Maxo, Just right.
On the Sense Blazer 200, good fit.
On the Smok Alien, just a touch of overhang if you're really looking for it.
On the Wismec Predator, fits fine.
Note: Predator gets HOT at 150 watts.
Last edited:
The CIGPET ECO12 with RBA section is simply awesome.
GREAT flavor and plenty of clouds.
Vaping at 100 watts with this build and it is performing perfect.
While using the stock 0.12Ω ECO T12 coil on the Wismec Predator at 150 watts the mod gets hotter than the tank.
If I were to chain vape like normal I'm sure it'd be even hotter than it has been.
GREAT flavor and plenty of clouds.
Vaping at 100 watts with this build and it is performing perfect.
While using the stock 0.12Ω ECO T12 coil on the Wismec Predator at 150 watts the mod gets hotter than the tank.
If I were to chain vape like normal I'm sure it'd be even hotter than it has been.
Last edited:
TFV12 coils work perfectly in it.