I use to have one and it was a cool unit. I only used it as an RDA.
Squonking was not a consideration in their initial design and engineering, it was an “oh shit, we forgot about a large market segment.” Their solution was to replace the posts and give you a hollow pin that feeds juice below the new posts where in theory it is supposed to seep out from under the posts. Well, the posts obstruct juice flow and make it impossible to actually squeeze more than a tiny puddle of juice into the juice well. $20 wasted on their squonk conversion kit.
I like it so much I actually bought two. I don't squonk on them, but I am totally confident Vaping Biker's review is spot on:
I was seriously irked at the time, I bought the red top cap at the time to match the mod. I even took it to a shop that did builds to see if they could figure out what was going on. I am not sure if it was the posts that got mixed up or if the holes were blocked since the kit was all matched up in storage.
Nah... if the coils are only 2.5mm ID you can bend the legs of the coils so the coils are positioned at the exact same height as the air holes, and they will perfectly fit─and, if you do that, then IMO they vape better, but then you also have to be careful to not burn your wicks in half so it's a little bit weird if you haven't gotten used to this thing yet.
