DNA 200 mod and Uwell Crown tank

[NinoCappuccin0]

The Crown Subohm tank has SS coils which are usable in wattage mode. I planned on doing this with my Hcigar VT200. How do I go about this?

 

[inspects]

Not sure what your asking. I just screw the Crown atty on and vape in wattage mode or SS TC mode on a different mod.
Doesn't the VT have wattage-power mode?

 

[centella4u]

Crown, even though is says SS, but I'd recommend using regular wattage mode (since I read somewhere that the legs are made from non-resistance material which may throw your tc sensing chip off).
I guess you're asking for the steps from priming which is very important. I'd also suggest you punch some pin holes on the wick as well to let the liquid flow better. Start from priming your coil with liquid on side and inside, install, fill tank, close, close all air holes first and take lots of puffs without pressing fire button. If possible, leave overnight. Put Crown on you mod and start with very low wattage and slowly and gradually work your way up.
Hope that's clear enough.


Sent from my iPad using Tapatalk

 

[Wingsfan0310]

Hook your mod up to Escribe. Then in the general tab set up one of your profiles for wattage vaping (power mode). You do this by simply checking the off box in the temperature section under settings. Don't forget after you are done to click the Upload Settings to Device tab at the top of the page. That will be the profile you use for power mode (Kanthal, SS, etc)

Cheers,
Steve

Edit If you do want to try and run the Crown SS coils in TC. I'd suggest trying the SS304 or 430 TCR or Curve since the legs are reported to be Nickel. Here's the link to the thread that walks you through setting up different wires/profiles on the DNA200. As always feel free to shoot me a PM if you have any questions!
Tips For Setting Up a DNA200 Mod (FAQ)