I found this and was wondering if it will work in my vapor shark dna 133?
http://vapefirmware.com/dna200/dna200-themes/breaking-bad-dna200-theme/
http://vapefirmware.com/dna200/dna200-themes/breaking-bad-dna200-theme/
Become a Patron!
DNA133 THEMES?
- Thread starter CashNVape
- Start date
I don't see why not. Just save it (noting where you saved it) on you PC. Hook up you mod to Escribe and click on the theme tab and load it.
PS I would save my old theme first in case you want to go back to it.
PS I would save my old theme first in case you want to go back to it.
Last edited:
i cant find the thread you helped me by linking me to a thread with all your uploads, i am using the NewUpdatedVT133 + the theme i just got from the post above, but i have notivced when installing a new coil it never ask if its a new coil, no sure where that setting is in escribe
Here's the link to the thread/post of my uploads. It's also in my signature. I think you only see it if you are om a PC. I don't see it if I'm on my phone.
Link to my Triade250, VT133, Lavabox M DNA 75, and VF133 Configuration Files
I believe the Evolv chips only ask if the difference is less than a certain amount (+ or - 25% is the default setting). If the difference is greater, it just assumes it's a new coil. If you want to see the message, fire an atty a couple of times, then unscrew it, press the fire button while it's still off to get the check atomizer message. Then screw it back on. You will then get the message asking you if it's a new coil when you try to fire it. I just tried it on a .31 ohm SS430 build I have. It asked New Coil .33 or Old Coil .31.
The setting for when it automatically locks in a new resistance is in the Mod Tab of Escribe.
Cheers,
Steve
Last edited: