DNA200 TC with Crown SS coils

[MidwestExpress]

Hey Everyone,

I have a Lavabox and am trying to get the TC for the stock SS .25ohm coils for the Crown tank dialed in. I was using the temp curve for just 316 and 304 SS. The coils are 316 SS but I read that folks were getting better results using the 304 settings. So I tried that and had decent results. I then went to steamengine and built the coil there and pulled the DNA mod info from there and uploaded it to my Lavabox. These settings plain do not work. It does the initial ramp and then it is like it just stops pumping power to it. If I switch to the profile I have setup for my Aromamizer, I get better results but not as good as straight VW.

Anyone having any luck with TC with the stock coils? If so, how do you have your profile setup? Sad to say, but I get better TC results with the Crown's stock coils with my Xcube II than I do with the Lavabox...

Here is a screen shot of my settings:

 

[Neunerball]

I've had good results with a CSV file, I downloaded from the Evolv forum (see post #8). In addition, I turned off the Preheat by setting the Preheat Time Limit to 0 (Zero). FYI, the crown's SS Coils are 316L.
http://evolvapor.forumchitchat.com/post/ss316l-help-7782022?pid=1289754163

 

[MidwestExpress]

I've had good results with a CSV file, I downloaded from the Evolv forum (see post #8). In addition, I turned off the Preheat by setting the Preheat Time Limit to 0 (Zero). FYI, the crown's SS Coils are 316L.
http://evolvapor.forumchitchat.com/post/ss316l-help-7782022?pid=1289754163

The links all go to the root of the site. I don't get to any downloads.

 

[Neunerball]

The links all go to the root of the site. I don't get to any downloads.

The following is the content of the file I'm using with my DNA 200 mod. Copy it into an editor of your choice (e.g. Notepad) and save it with an extention of .csv (e.g. SS316L.csv)

Temperature (degF),Electrical Resistivity
-58,0.923064
68,1
212,1.12
302,1.15
392,1.19
482,1.2425
572,1.2745
800,1.3605

 

[MidwestExpress]

I have this loaded up. Thank you! What temp are you running this at?

 

[ChrisL]

Thanks guys for reminding me why I didn't get a DNA 200 device. . I think Ill go hit my Fuchai now...

 

[MidwestExpress]

Thanks guys for reminding me why I didn't get a DNA 200 device. . I think Ill go hit my Fuchai now...

It works great on my stainless fused Clapton's I build. It is just those Crown coils. Neither of my mods fire them correctly right now.

Sent from my Nexus 7 using Tapatalk

 

[Neunerball]

I have this loaded up. Thank you! What temp are you running this at?

The temperature depends on the e-juice I'm using in either of my tanks. It's anywhere between 360F and 490F.