Become a Patron!

Dovpo Topside Dual reading resistance too low

theclaw20

Bronze Contributor
Member For 3 Years
I've had my Topside Dual for a few days now and with each build I put in I notice that it reads the resistance low. A coil that should read 0.61 based on my Vape Tool coil calculator that also reads at 0.61 on my Ijoy regulated mod reads at 0.56 on the Dovpo. A 0.19 coil was reading at 0.17. It keeps its reading steady and works fine, so I guess I am not too concerned, but has anyone else had this issue?

I tried updating the firmware but the computer doesn't recognize that I have anything plugged in.
 

MyMagicMist

Diamond Contributor
ECF Refugee
Member For 5 Years
Agree with @MrMeowgi. Usually if you can get within +/- 0.05 it's not too concerning. Got a Topside Lite that reads my 0.30 coil as about 0.27. It reads about 0.28 on a Pulse vape mod. I'm not broken up over it. Know it is still within relatively safe tolerances. Both regulated devices fire it.
 

nadalama

Senior Moderator
Staff member
Senior Moderator
VU Donator
Diamond Contributor
Member For 4 Years
VU Patreon
Yes, I've also had that happen, and as long as resistance is not widely fluctuating, it hasn't been a problem.
 

VU Sponsors

Top