Dragon Mech Mod - Is The RDA Pin Protruding Far Enough?

[TrackDay]

I'm wanting to use a Mini Buddha on my Dragon mech mod clone but unfortunately the 510 pin on the atty isn't adjustable. I've taken a picture of how far the 510 protrudes and was just wondering whether it would be safe to use?

Cheers.

 

[r055co]

It should be, unscrew the 510 deck and pull out the pin. They very well may have put a 510 pin that doesn't have a slot, it's a Clone and expect Clones to have screw ups and poor machining.

 

[TrackDay]

It should be, unscrew the 510 deck and pull out the pin. They very well may have put a 510 pin that doesn't have a slot, it's a Clone and expect Clones to have screw ups and poor machining.

No worries. It's actually an authentic. I'll try what you suggested.

 

[pulsevape]

1.5 to 2 mm is good for me...this looks good.

 

[r055co]

No worries. It's actually an authentic. I'll try what you suggested.

No not the RDA, the Dragon Clone.

If you're missing the 510 pin DO NOT try to use it or you're fucked

 

[pulsevape]

Hard to be positive dude, because the guy who made the mod and the people who reviewed all tend to be absolute cretins. who don't do a very good job showing you the 510 pin system or how to adjust for battery rattle.like chimps they are so obssesed by the button system they just disregard the rest of the mod....I suspect it has a spring loaded pin system.like a GP paps.if that is the case you can use any atty on it. I watched 3 videos and none of them really showed the top cap detail at all.