First Build Questions

[JamesB7579]

Hi,
I would just like to know what would be the best build for me to start on? I do not know what gauge wire to use, nor do I know how many wraps to do and how big to make them for good flavor and clouds. Thanks, James

 

[TF Vaping]

Mod, batteries, RDA is info we must know. Then we'd be better suited to answer


Sent from my Nexus 6 using Tapatalk

 

[JamesB7579]

Mod, batteries, RDA is info we must know. Then we'd be better suited to answer


Sent from my Nexus 6 using Tapatalk

Ipv3 Li, Samsung 25r 2500mAh, still deciding on what rda to get, ballin on a budget

 

[BreeZyCloudZ]

Are you getting kanthal or nichrome?

 

[BreeZyCloudZ]

My very first build was with 24G Kanthal 5 wrap around 2.5 duals

 

[wheelie]

6 to 8 wraps of 28 gauge wire to start. Heat up quick and good clouds and flavor. CHEERS!

 

[Neunerball]

In my RDAs, I like my standard dual coil w/ Kanthal A1. Usually, it clocks in at around 0.3 Ohm. It's a 6/5 wrap 3 mm ID. My DIY juice and I like it between 50-60W.

 

[JamesB7579]

THANK YOU to everyone that helped me out on this is means a lot to have a better understanding now!!

 

[JamesB7579]

6 to 8 wraps of 28 gauge wire to start. Heat up quick and good clouds and flavor. CHEERS!

Thanks! now if one coil came out to .5ohms (im not saying it would but using this as an example) then what would the ohms be with two .5ohm coils????

 

[nightshard]

0.25

 

[Neunerball]

Thanks! now if one coil came out to .5ohms (im not saying it would but using this as an example) then what would the ohms be with two .5ohm coils????

Refer to http://www.steam-engine.org/coil.asp? as a guideline. Read the "How it works" after clicking on it in the bottom left.

 

[JamesB7579]

Refer to http://www.steam-engine.org/coil.asp? as a guideline. Read the "How it works" after clicking on it in the bottom left.

THank you,, very helpful information from that website