S13hitman
Member For 1 Year
Okay I liked using my X-priv during the day and miss it. I'm normally really good at fixing shit but I believe I didn't replace the ground or the pin spring correctly as I had disassembled the mod due to some issues.
Last week the 510 connection just spun in place which wouldn't allow me to remove my tank. The X-priv is not built like other Smok mods where the 510 connection is easily accessible, you have to completely remove and de-solder the motherboard. There is NO NUT to tighten so please don't add your 2cents if you are just guessing or don't know.
What I did was add a little epoxy to the 510 housing/connection to the mod so it wouldn't spin anymore. It wasn't the strongest epoxy but thought it would have done the trick. I let it cure for 2 days and it spun again after installing the tank.
What I need help with is 2 thing; What will hold that 510 super tight. Jb weld or is there something better?
And when I put it back together it turned on but wouldn't fire or detect a coil, could this of been from the spring on the inside? Something wasn't making contact and I swear it was put back exactly the way it came out.
See pictures:
Here is a little of taking it apart:
Last week the 510 connection just spun in place which wouldn't allow me to remove my tank. The X-priv is not built like other Smok mods where the 510 connection is easily accessible, you have to completely remove and de-solder the motherboard. There is NO NUT to tighten so please don't add your 2cents if you are just guessing or don't know.
What I did was add a little epoxy to the 510 housing/connection to the mod so it wouldn't spin anymore. It wasn't the strongest epoxy but thought it would have done the trick. I let it cure for 2 days and it spun again after installing the tank.
What I need help with is 2 thing; What will hold that 510 super tight. Jb weld or is there something better?
And when I put it back together it turned on but wouldn't fire or detect a coil, could this of been from the spring on the inside? Something wasn't making contact and I swear it was put back exactly the way it came out.
See pictures:
Here is a little of taking it apart: