mkhilario
Bronze Contributor
Member For 4 Years
Member For 3 Years
Member For 2 Years
Member For 1 Year
My Freakshow Mini would seep juice from the edges of the top cap like crazy. Not from the air holes. I finally figured out that this was being caused by fitting it flush to my mod. If I leave a tiny gap by adjusting my positive pin so that I can see a sliver of light between the mod and the FS Mini, the leak disappears. Just throwing this out here in case someone else has a similar issue and this helps.
Edit: Ended up filing the bottom of the bell cap until it was slightly higher than the bottom of the atomizer so that the cap edges won't make contact with the mod when fitted flush.
Single coil builds will leak more than duals. I don't "paint" anymore. I just pop off the DT and drip onto the center post, appx 10 drops and run a dual coil build. No more Leakshow.
Edit: Ended up filing the bottom of the bell cap until it was slightly higher than the bottom of the atomizer so that the cap edges won't make contact with the mod when fitted flush.
Single coil builds will leak more than duals. I don't "paint" anymore. I just pop off the DT and drip onto the center post, appx 10 drops and run a dual coil build. No more Leakshow.
Last edited: