http://shpws.me/Hu8I
I've tried the straw method, shaking, steeping. I like mixing and steeping, but mixing with a cut straw is a pain in the ass at best. Especially with multiple flavors. I wanted something simple to use and easy to clean and it needed to fit inside most ejuice bottles without hassle. The rod is 12cm long and the cross shaped mixer is 1cm x 1cm and 1.5cm tall. The rod is 3mm in diameter so it will work with a drill or dremel.
The is my first go at 3D designing/printing, if you have any feedback or can improve on it, please feel free to do so!
There is no fee added on, the shapeways link is at cost. I think mine was about $7 shipped.
Cheers and I hope someone else can use this as much as I can.
I've tried the straw method, shaking, steeping. I like mixing and steeping, but mixing with a cut straw is a pain in the ass at best. Especially with multiple flavors. I wanted something simple to use and easy to clean and it needed to fit inside most ejuice bottles without hassle. The rod is 12cm long and the cross shaped mixer is 1cm x 1cm and 1.5cm tall. The rod is 3mm in diameter so it will work with a drill or dremel.
The is my first go at 3D designing/printing, if you have any feedback or can improve on it, please feel free to do so!
There is no fee added on, the shapeways link is at cost. I think mine was about $7 shipped.
Cheers and I hope someone else can use this as much as I can.
Last edited:
