Griffin mini rta issues

[WarrLordd]

Anyone else have issue with Griffin mini rta. I dropped it once on some carpet not to say it was that much of a hard fall however when I screw it back on it kept saying check atomizer. Only way I got it fixed was by turning the bottom pin screw a little and ever since I been having issues sometimes it shows correct resistance other times it shows a higher resistance above 1.8 and even get a high ohm reading. What I tried so far was trying to tighten the screw but it keeps spinning I also tried to see if I could disassemble it but I don't think it can anyone has a solution ?


Sent from my iPhone using Tapatalk

 

[Mattp169]

if the screw doesnt stop spinnning something is broke inside like the post is broken, or something that is press fitted ads become un press fitted. Ive yet to completely disassemble one of these. Hopefully someone who has will chime in

 

[WarrLordd]

Hmm probably arg and its my fav tank


Sent from my iPhone using Tapatalk

 

[Mattp169]

ok i just had a similar issues but not the same
mine was shorting out with no wires in it.
SO usncrew the screw
Now look in there that hole where the screw come sout of has a grayish looking insulator and then another piece of brass
that piece of brass attaches the top posts
so get a wide thing screw driver and unscrew it
then with a this screw driver seperate the top posts from teh bottom
makes sure everything is completely clean and reassemble
that might do the trick