Hey all I'm a new member looking to learn how to build safely. I have been vaping for 6 months after 28 years of smoking cigs. Hate the taste, and smell of those evil things now. I recently started building basic single coils on my Kanger RBA. I will be getting my Ohm meter tomorrow. I just graduated from the eLeaf iStick 50W to a IPV4s. I have or am getting the right gear, now I just need the proper know how to make it all sing. Any advice will be appreciated. Thanks.
Become a Patron!
Hello Vaping Underground
- Thread starter Baxman500
- Start date
Hey glad to have ya here! Its sounds like you got building under control now its time to experiment. Just change things up try twisted wire or clapton also try getting into stainless steal. I've got a feeling 90% of all coils will go to it in the nxt yr. And maybe get an rta bc the kanger is limited on space and you wont be able to use the ipv4s at its full potential.
Any suggestions on where to go as far as rta? I'm trying Ni200 26G now, and it's a total bust. I make the coil as evenly spaced as possible. I go as far as to use a jewlers loop to look for any problems. Then wick it, and I put the box on Jules not power, set resistance, and it just says low resistance and won't fire at all. Not sure where i'm messing up. I wanna say the ohms were at .045 when resistance was set. I just took it apart again. I wana taste the difference between to 2 metals but can't. It's driving me bat shit.
