Hi all, first time poster long time lurker . So I just got the aromamizer supreme rdta, and am having an issue with it. For some reason my juice flow control only opens to half mast and will not turn past there.. I broke it down and I dont see any parts missing, even both of the teeny little pins are there. I havent gotten a dry hit with my current build but I could see it becoming an issue on a thirstier coil set up. Any input would be greatly appreciated.
Become a Patron!
help with steamcrave aromamizer supreme.
- Thread starter Grimmclouds
- Start date
You got some pics?
Was it like this when you first got it?
If yes!
Why didn't you return it
You have to make sure you align those pins and all the moving parts correctly
Sent from my iPhone using Tapatalk
My camera is terrible but Ill try to get some pics. I won it in a raffle at the local b&m, I'm sure I could still take it back. Just figured id try my hand first cause I already had a build and juiced up when I noticed
When I first got it, I noticed there was only one of the pins in it so I put one in from the parts kit. I will try swapping them around and stuff once I get through this 7 ml tank haha. Was mostly just curious if it was a common occurence or not
I think you didn't put the parts correctly
That's what I'm thinking, this doesn't happen all the time...
Sent from my iPhone using Tapatalk
Disassemble the tank and grab the bottom part look from above and see if when you move the JFC it moves all the way from side to side, also check if the marking on the side are aligned with the juice flow holes meaning that when looking from above the juice holes are fully open and when looking from the side the dot is near the fully open mark.
Also the JFC portion can be placed in two ways the right way and flipped around (which is the wrong way).
Also the JFC portion can be placed in two ways the right way and flipped around (which is the wrong way).
I took it all apart and cleaned again, jfc seemed to work fine. Screwed everything back again and juiced up.. Sometimes it will open all the way sometimes only half. Thinking there is a burI or bump in the machining I havent noticed