How do your unscrew the tank on a knager 200w?

[Elliott20]

I want to change the tank on my kanger 200w, how do i do this???

 

[UncleRJ]

Buy a new tank, unscrew the old tank and screw on the new tank perhaps?

As usual, CCW to remove and CW to install.

 

[SMOKIE]

I want to change the tank on my kanger 200w, how do i do this???

Change the tank itself or do you mean the coil head in the tank?

 

[Elliott20]

Buy a new tank, unscrew the old tank and screw on the new tank perhaps?

As usual, CCW to remove and CW to install.

I mean the whole tank with the airflow. Idk how to on the kbox because it just adjusts the airflow and i cant unscrew it.

 

[Elliott20]

Change the tank itself or do you mean the coil head in the tank?

I mean the whole tank with the airflow. Idk how to on the kbox because it just adjusts the airflow and i cant unscrew it.

 

[SMOKIE]

I mean the whole tank with the airflow. Idk how to on the kbox because it just adjusts the airflow and i cant unscrew it.

You had to screw down the tank when you first used it, if that tight means you over turned too tight so take the batteries out and put it in the freezer for a half hour then try unscrewing the tank.

 

[Elliott20]

You had to screw down the tank when you first used it, if that tight means you over turned too tight so take the batteries out and put it in the freezer for a half hour then try unscrewing the tank.

Ok ill try that thanks

 

[Moueix]

I have a pregnant girlfriend, and I also need advice.

I hope the freezer trick works for you. That's not going to work for the girlfriend.

 

[Waffle Baron]

This actually happens on mine from time to time. Must be using the kbox 200 with the toptank mini that comes with it. Get a pair of large pliers, put a little electrical tape on the ends so you dont scratch it and turn it from the very bottom until it loosens. Not sure why it snugs up like that, but it is a pain in the ass.