Become a Patron!
I need help setting my rx200
- Thread starter Tegoz123
- Start date
If you have never built coils before, than I recommend prebuilt coils. Figure what ohms you like to vape at and buy accordingly. Stick with ss for now. You can also buy a coil box which has different types of coils at different resistance to learn what you like.
Lots of videos talk about wicking you can watch. But each atty is different so you will need to find the sweet spot for yours and adjust the wick accordingly.
Temp control on reuleaux is hit or miss depending on your atty. So maybe run it on watt mode.
Lots of videos talk about wicking you can watch. But each atty is different so you will need to find the sweet spot for yours and adjust the wick accordingly.
Temp control on reuleaux is hit or miss depending on your atty. So maybe run it on watt mode.
Last edited:
I have prevuilt coils and I put them in but I do not know how to setup up the ohms to the coils..when i put it on ss..it tells me atomizer short,help please?If you have never built coils before, than I recommend prebuilt coils. Figure what ohms you like to vape at and buy accordingly. Stick with ss for now. You can also buy a coil box which has different types of coils at different resistance to learn what you like.
Lots of videos talk about wicking you can watch. But each atty is different so you will need to find the sweet spot for yours and adjust the wick accordingly.
Temp control on reuleaux is hit or miss depending on your atty. So maybe run it on watt mode.
You've got a short, check your coils, screws, 510 pin, etc.
Also watch some YouTubes on installing coils, that will help a lot.
I think it's my 510 because it also says atomizer not found,do I have to buy a new one?
Hard to say without physically inspecting it. Try cleaning it with alcohol, connect other devices on it etc.
Sent from my Nexus 6 using Tapatalk
Troubleshooting time!
Isolate the problem. Is it your tank or mod? Check a tank on other mods. Check a mod with other tanks. The Reuleaux is notorious for bad 510 connections. If it's your mod use a small screwdriver to jiggle the 510 loose (take out a battery first).
Sent from somewhere in Vietnam.
Isolate the problem. Is it your tank or mod? Check a tank on other mods. Check a mod with other tanks. The Reuleaux is notorious for bad 510 connections. If it's your mod use a small screwdriver to jiggle the 510 loose (take out a battery first).
Sent from somewhere in Vietnam.
Also on my rx200 I often use cotton buds and rubbing alcohol to clean out the 510 connection, also the pin can sometimes get stuck down. So I push it down a few times using a flat head screwdriver until it's working properly again
Sent from my GT-I9505 using Tapatalk
Sent from my GT-I9505 using Tapatalk
Did you tried just screwing ur atty on/off a few times ive had simular problems with my rx200.
, uses the TM2 deck.
U've also got the normal Glacier Gen3 RDA mate
, uses the TM2 deck.
yes I do, but the OP did state "gen30" (think they fat fingered the 0) which is the RDTADid you tried just screwing ur atty on/off a few times ive had simular problems with my rx200.
U've also got the normal Glacier Gen3 RDA mate
http://vaperzcloud.com/collections/tanks/products/glacier-gen3-red
Last edited:
I haven't said a thing mateyes I do, but the OP did state "gen30" (think they fat fingered the 0) which is the RDTA
http://vaperzcloud.com/collections/tanks/products/glacier-gen3-red
