If you could only pic 3

[Mike H.]

Im looking for some input on some rda's...which 3 would you pick and why?...i do want flavor but not a very restrictive air flow...Any input would be greatly appreciated.

Heres the choices

Ehpro Tobh
Tobeco Veritas
Tobeco Marquis
Tobeco CEO
Tobeco Omerta
"No name" freak show
"No name" Velocity
"No name" Doge V2
"No name" Mutation X V4

 

[State O' Flux]

I can't speak to the quality of clones, as I don't have any in the models listed... but if the clones are well made, at or near 1:1 and of quality materials (PEEK insulation is just about mandatory for the high coil temperatures associated with low resistance)... I'm quite fond of my Velocity, Omerta and Veritas.
Why? I've owned or tested many of the others you list, and have settled on top, or at least labyrinth air inlet designs as my preference. I prefer the flavor, and they're far less prone to leaking.

I usually run RDAs at 0.25~0.45Ω with 80% or more VG DIY juice - with best flavor as my primary goal. 80% VG at that resistance, with optimized coil surface area (I use only mechs, so my builds are far more Ohm's law critical) and heat flux in the high 200~mid 300 range, produces more than satisfactory vapor density and volume.

 

[Jah]

1. velocity - good flavor/clouds, great build deck, perfect for temp control or regular kanthal
2. Marquis - it just looks so sexy and clean, nice coiling helpers (heard the clone was a bit leaky though)
3. Veritas - clone is well built, leak resistant, easy to build single coil, good flavor

 

[Haadkoe]

Veritas, Marquis, Derringer are my 3 favorite rda's.

 

[Mike H.]

Thanks for the input everyone..I decided to go with the velocity, marquis and the Ceo and see how it goes.

Looking at the marquis and veritas, the marquis "appears" to be easier to build on somewhat to me so, im gonna give it a try first.

Im hoping the velocity will end up as my main go to rda..seems to be versatile enough to be any type of atty you want it to be.