IPV 3 Li with Crown Uwell 0.5 prebuild coil ( ohm reading go nuts ! )

[jiremi21]

HI to all i would wish to have some help from the experts here

currently my ipv 3 li reading with crown uwell is
am using sony vtc 5 battery

15watts
5.92v
2.34ohm


what is going on ?? is this correct ? as i am using the prebuild 0.5ohm coil

can someone explain to me is this correct or my ipv3 go bonkers or what is it i really could not figure it out

your help is deeply appreciated

 

[AmandaD]

You need to go way up in wattage to get the most from a 0.5 crown coil (I'd say at least 50 watts). If the IPV is reading it at 2.34 try cleaning the 510 with alcohol first.

Make sure you prime that coil really well first though

 

[Mattp169]

first
make sure all connections are clean
second
make sure everything is screwed together well
third
if the ohm readng is still nowhere close to .5

try to check it on a different mod or ohm reader

if its the same on another mod change coil
if the other mod or ohm reader says around .5
something is wrong with your 3li

 

[jiremi21]

i have set and change to TC setting on IPV 3 Li instead it reads at 0.5 ohm

right now i do not know should i go to power mode instead of TC mode , i know IPV 3 Li does not support SS Coil TC mode

any advice ?

 

[smacksy]

i have set and change to TC setting on IPV 3 Li instead it reads at 0.5 ohm

right now i do not know should i go to power mode instead of TC mode , i know IPV 3 Li does not support SS Coil TC mode

any advice ?

The .5 ohm SS coil should be ran in power mode at about 50-60w..TC mode is for the Ni200 coil only...

Sent from my XT1080 using Tapatalk

 

[MrScaryZ]

i have set and change to TC setting on IPV 3 Li instead it reads at 0.5 ohm

right now i do not know should i go to power mode instead of TC mode , i know IPV 3 Li does not support SS Coil TC mode

any advice ?

You can use TI mode for SS on the IPV LI there will be a small offset of about 40 degreees but it will work find or you can do it in power mode ...50/60 as someone said above

 

[Powerman]

You can use TI mode for SS on the IPV LI there will be a small offset of about 40 degreees but it will work find or you can do it in power mode ...50/60 as someone said above

That not close to true. The TCR for SS is not even close to Ti or Ni. The box will never temp limit. It will put out what ever joule rating you put in. There is no temp offset that will work within the temp range of P4Y. You would have to set it way below minimum temp, and even then it would be wildly inaccurate.

 

[jiremi21]

Alright for example i do not know where goes wrong ?

I am using stock dual coil 0.25 ohm but on my ipv 3 li it reads 0.6 ohm ?
is there a problem with my ipv3 li or my coils ?
my ohm meter has not arrive yet could not check it