Is there an adapter?

[Gregjl]

Hello, I picked up a reo grand clone to see what it's all about and now I'm having a hard time finding an rda that will work with it. What should I be looking / asking for. Chalice is sold out everywhere and b&m 's near me don't handle bottom fed anything.

Thanks

 

[Diescum88]

Your best bet is to file down the top of it where the 510 is, the clones are based on the old design not the lp's

Sent from my SAMSUNG-SM-G930A using Tapatalk

 

[Huckleberried]

Most RDA's that are compatible will say they have a bottom fill pin included. I have a velocity v2 RDA that came with one installed, then had the regular pin included with the accessories.

 

[Gregjl]

Your best bet is to file down the top of it where the 510 is, the clones are based on the old design not the lp's

Sent from my SAMSUNG-SM-G930A using Tapatalk

Thank you, I'm a dumbass. Why didn't I think of that.

 

[Diescum88]

Thank you, I'm a dumbass. Why didn't I think of that.

Lol naw your not a dumbass I just remembered reading about other people doing it cuz of the same issue

Sent from my SAMSUNG-SM-G930A using Tapatalk

 

[SirRichardRear]

tsunami 24 comes with a squonker pin and is a great RDA for around 25 bucks

 

[MyMagicMist]

Not the seller/s here nor am I promoting anyone but here are some adapters.

One , two , three

You need to look and see that the adapter/s have a hole clear through. I think I read somewhere most of the Eleaf Istick adapters are designed to have a hole through. I'm using one with a 22 mm Velocity deck and a Reo Grand clone just fine. I did file down one of my Grand clones though to meet the LP form factor, then I saw I could use the adapter. *chuckles*

 

[HondaDavidson]

Thank you, I'm a dumbass. Why didn't I think of that.

Just be carefull you don't grind it down TOO FAR.. There should be a little bit of the cup left.... Go too far, you will have a big gap under the atty. use your dripper with the longest 510/pin to check depth. Easier too remove more material, later, if needed, than to fill the gap.

 

[Gregjl]

Just be carefull you don't grind it down TOO FAR.. There should be a little bit of the cup left.... Go too far, you will have a big gap under the atty. use your dripper with the longest 510/pin to check depth. Easier too remove more material, later, if needed, than to fill the gap.

Thanks, I put that mod on the back burner for now, I don't think I went too far I went even with the base where the rda would.. I wasn't crazy about the fire button anyway. The last b&m I went Into couldn't help with the squonk pin rda but another mech mod caught my. Big sale, they've looking to stop carrying clones so I helped them out. X2, one of which was the fu clone. I really like that one with a aeolus rda.