I just got my shiny (well not shiny, it's black) new Cubis in the mail but unfortunately my Cuboid has been extremely delayed in shipping. Only thing else I have is an old Panzer Blackhawk 18650 mechanical mod to run it with until my Cuboid gets here. How should I set up my Cubis so I don't frag it? I have some 30/70 12nic ready to run. Thanks in advance!
Become a Patron!
Joyetech Cubis mod worry!!!
- Thread starter iconis1000
- Start date
I'm just getting back into vaping and was never really knowledgeable to begin with. I want to make sure I use the best atti for the setup I have right now.
So are you asking if you can run your Cubis tank on the Panzer Blackhawk Mech Mod?
The answer is yes, you can, but it won't perform as well as on a regulated device. Just keep in mind you can't use the Ni200 coil (0.2ohm) without a TC (Temp Control) device. Stick the SS (0.5ohm and 1.0ohm) or Clapton (1.5ohm) coil in and you'll be fine. Again, just keep in mind it won't perform as well as it will on a regulated mod.
Also, make sure you have a quality battery, since it is a mech mod after all.
The answer is yes, you can, but it won't perform as well as on a regulated device. Just keep in mind you can't use the Ni200 coil (0.2ohm) without a TC (Temp Control) device. Stick the SS (0.5ohm and 1.0ohm) or Clapton (1.5ohm) coil in and you'll be fine. Again, just keep in mind it won't perform as well as it will on a regulated mod.
Also, make sure you have a quality battery, since it is a mech mod after all.