Become a Patron!

Joytech vt leaking

I need some help? I have been using my joytech since new years eve now. the first week and a half no problems, then it started to leak, weather full or low it leaks, and you get juice in your mouth. was told to change coil. tried the ti coil seemed ok for one day same problem. now have got some more coils but the are 0.5 ohm ok for half a day then problem back again, and since I have put the new bigger coil in the display has changed. watts at the top, volts in the middle and atomizer at the bottom. dose anybody no what the problem is and why has the display changed?
 

Model_A_Ford

Bronze Contributor
Member For 4 Years
Member For 3 Years
Member For 2 Years
Member For 1 Year
Can you describe what you mean by leaking.

If it's flooding (too much liquid at the coil), this is usually a seal that is not air-tight.

Lik
e when you refill, the coil usually gets flooded for a few pulls, then stops when the tank gets it's vacuum back. If there's an air leak then it will continue to flood.

Ch
eck to make sure all the o-rings are in place and everything seals correctly.
 

DED420

Silver Contributor
Member For 4 Years
The screen has switched over to power mode because the 0.5ohm coils for the eGo One Mega are Kanthal, and can't be used in TC like Ni/Ti/SS coils can. The problem is the eGo One Mega coils SUCK!!!!! If you have to use this tank, get the CLR coils. They are Kanthal, but they can be re-wicked and re-built, and function a lot better than all the other coils. I haven't had any issues with the CLR coils, but all the other coils (both Ni/Ti/stock Kanthal) slowly flood after it sits for a couple minutes, they are just very poorly designed, which is why they burn out so quick. If you triple tap the fire button, you can scroll through all the different modes
Power : Regulated
Bypass : Unregulated (like a mech)
TC Ni : Nickel/Ni200 (TC ONLY)
TC Ti : Titanium (TC ONLY)
TC SS : Stainless Steel (TC and Power)
 
I need some help? I have been using my joytech since new years eve now. the first week and a half no problems, then it started to leak, weather full or low it leaks, and you get juice in your mouth. was told to change coil. tried the ti coil seemed ok for one day same problem. now have got some more coils but the are 0.5 ohm ok for half a day then problem back again, and since I have put the new bigger coil in the display has changed. watts at the top, volts in the middle and atomizer at the bottom. dose anybody no what the problem is and why has the display changed?
Can you describe what you mean by leaking.

If it's flooding (too much liquid at the coil), this is usually a seal that is not air-tight.

Like when you refill, the coil usually gets flooded for a few pulls, then stops when the tank gets it's vacuum back. If there's an air leak then it will continue to flood.

Check to make sure all the o-rings are in place and everything seals correctly.
everything is sealed, this is the 3rd coil so far. it leaks from the air vent at the bottom? and when you inhale a lot of the time you get juice in your mouth. and it makes a crackle sound. don't know if there is something wrong with the tank? do I get a better tank? if so what? thanks
 
The screen has switched over to power mode because the 0.5ohm coils for the eGo One Mega are Kanthal, and can't be used in TC like Ni/Ti/SS coils can. The problem is the eGo One Mega coils SUCK!!!!! If you have to use this tank, get the CLR coils. They are Kanthal, but they can be re-wicked and re-built, and function a lot better than all the other coils. I haven't had any issues with the CLR coils, but all the other coils (both Ni/Ti/stock Kanthal) slowly flood after it sits for a couple minutes, they are just very poorly designed, which is why they burn out so quick. If you triple tap the fire button, you can scroll through all the different modes
Power : Regulated
Bypass : Unregulated (like a mech)
TC Ni : Nickel/Ni200 (TC ONLY)
TC Ti : Titanium (TC ONLY)
TC SS : Stainless Steel (TC and Power)
what size coil would you use? and what tank? will this all so stop the leaking from air vents? thanks
 

DED420

Silver Contributor
Member For 4 Years
The CLR coils for the eGo One Mega come pre-made, but they screw apart so you can re-wick them when the cotton goes bad, and you can take them apart and put a different coil in too, although that's a little more complicated. You can get a 5 pack for like $12, and they are 0.5ohm out of the box if I'm not mistaken. I have yet to have any leakage at all, and I toss this thing around a lot when I do use it, so you shouldn't have any issue with leaking/flooding anymore.

But personally, I would just get a new tank (if you have the money to spend). I would recommend the UWell Crown tank, comes with SS coils (in various Ohm ratings, and can be run in TC and Power), the vapor production is great, the flavor is astounding, and it doesn't leak a drop. Plus it's top filling, so it's very convenient, and since it's a very popular tank, the coils are readily available (and an RBA can be purchased separately if you want to build coils in the future).

I have this tank and it blows me away, can't put it down because it tastes toooo good!
 

VU Sponsors

Top